Physics 1 Practice

Unit 2 of 8

Forces and Newton’s Laws

Free-body diagrams, Newton’s three laws, friction, tension, inclines, and connected objects.

10 problems: 4 multiple choice, 2 multiple select, 4 free response. Use g = 10 m/s² throughout.

A tall orange gantry crane spanning a harbor, with a hook hanging from a cable at the top beam

Photo: W.carter, CC0 1.0 Universal Public Domain Dedication. Image credits

Overview

A force is a push or a pull that one object exerts on another. Every force has a source you can name. Earth pulls down on objects (gravity). A surface pushes perpendicular to itself (the normal force) and resists sliding along itself (friction). A rope or string pulls along its length (tension). If you can't name the object exerting a force, the force probably isn't there. "The force of motion" is not a force.

Newton's second law connects forces to motion: the net force on an object equals its mass times its acceleration, Σ F = m a. The net force sets the acceleration, not the velocity. An object can move fast with zero net force (constant velocity) or be momentarily at rest with a large net force (a ball at the top of its flight).

Newton's third law says forces come in pairs. If A pushes on B, then B pushes on A with a force of the same size in the opposite direction. The two forces act on different objects, so they never cancel each other out. Start almost every problem by drawing a free-body diagram for one object at a time.

Key equations

EquationWhat it’s for
Σ F = m aNewton’s second law. Apply it separately along each direction.
Fg = m gWeight near Earth’s surface, with g = 10 m/s².
fk = μk FNKinetic friction on a sliding object.
fs ≤ μs FNStatic friction adjusts to whatever is needed, up to a maximum.
FA on B = −FB on ANewton’s third law: equal size, opposite direction, different objects.
m g sin θ and m g cos θComponents of weight along and perpendicular to a ramp tilted at angle θ.

All of these are on the printable equation sheet.

Common mistakes

  • Assuming the normal force always equals m g. It is whatever size keeps the object from moving into the surface: larger if something presses down, smaller if something pulls up or the object is on a ramp.
  • Drawing a force in the direction an object is moving just because it is moving. An object moving at constant velocity has zero net force.
  • Canceling third-law pairs. The two forces act on different objects, so they never appear on the same free-body diagram.
  • Setting the tension in a string equal to the weight of a hanging object while the system is accelerating.
  • Using μs FN for static friction when the object isn't on the verge of slipping. Static friction is only as large as it needs to be.

Practice problems

Work each problem on paper before opening its solution. Multiple-select problems have exactly two correct answers.

1Problem 1, Multiple choice

  • Conceptual

A book rests on a table while a student pushes straight down on it with her hand. How does the normal force from the table on the book compare to the book’s weight?

  1. Choice A: It is greater than the book’s weight.
  2. Choice B: It is equal to the book’s weight.
  3. Choice C: It is less than the book’s weight.
  4. Choice D: It is zero, because the push and the weight balance each other.
Show solutionHide solution

Worked solution

FN (table on book)Fg (Earth)Fhand

Three forces act on the book: gravity from Earth (down), the push from the hand (down), and the normal force from the table (up).

The book is at rest, so the net force is zero. The upward force must equal the total downward force: FN = Fg + Fhand.

So the normal force is greater than the weight. Pushing harder makes the table push back harder.

Answer: A.

2Problem 2, Multiple choice

  • Predict & explain

A student stands on a bathroom scale in an elevator. The elevator is moving upward and slowing down as it nears the top floor. Compared with the student’s weight, the scale reading is

  1. Choice A: greater
  2. Choice B: the same
  3. Choice C: less
  4. Choice D: zero
Show solutionHide solution

Worked solution

The scale reads the normal force it exerts on the student.

The elevator moves up but is slowing down, so its acceleration points down. The student has the same acceleration, so the net force on the student points down.

For the net force to point down, the upward normal force must be smaller than the downward weight: FN = m(g − a).

Notice that the direction of motion doesn't decide the answer. Only the direction of the acceleration does.

Answer: C.

3Problem 3, Multiple select

  • Conceptual

A small car and a heavy pickup truck collide head-on. Which two statements about the collision are correct? Select two answers.

  1. Choice A: The force the truck exerts on the car is the same size as the force the car exerts on the truck.
  2. Choice B: The truck exerts the larger force because it has more mass.
  3. Choice C: The car has the larger acceleration.
  4. Choice D: The car exerts the larger force because it was moving faster.
Show solutionHide solution

Worked solution

The truck pushing on the car and the car pushing on the truck are a Newton's third law pair. They are always equal in size, no matter the masses or speeds. A is correct, and B and D are wrong.

From a = F/m, the same size force produces a larger acceleration on the object with less mass. C is correct. That is why the people in the car are in more danger.

Answers: A and C.

4Problem 4, Free response

  • Ranking
  • Paragraph argument
Four blocks sit on a level, frictionless floor. Each is pulled by a single horizontal force.
BlockMassPulling force
A2.0 kg10 N
B4.0 kg10 N
C4.0 kg24 N
D1.0 kg4.0 N
  1. Rank the blocks by the size of their acceleration, from greatest to least.
  2. A student says, “Blocks A and B have the same force on them, so they have the same acceleration.” Explain what is wrong with this reasoning.
Show solutionHide solution

Model answer

(a) With only one horizontal force, that force is the net force, so a = F/m. A: 10/2.0 = 5.0 m/s². B: 10/4.0 = 2.5 m/s². C: 24/4.0 = 6.0 m/s². D: 4.0/1.0 = 4.0 m/s².

Ranking: C > A > D > B.

(b) Acceleration depends on both the net force and the mass. A and B feel the same force, but B has twice the mass, so it has half the acceleration. A strong answer says that the same force spread over more mass produces less acceleration, a = F/m.

5Problem 5, Free response

  • Calculation
  • Paragraph argument
A 3.0 kg block on a frictionless table is tied to a light string that passes over a light, frictionless pulley to a hanging 1.0 kg block. The blocks are released from rest.
  1. Describe the forces on each block, as you would show them on free-body diagrams.
  2. Calculate the acceleration of the blocks.
  3. Without calculating, explain why the tension in the string must be less than 10 N. Then calculate the tension.
3.0 kg1.0 kg
Show solutionHide solution

Model answer

(a) Block on the table: weight, 30 N down. Normal force, 30 N up. Tension T, toward the pulley. Hanging block: weight, 10 N down. Tension T, up.

(b) Treat both blocks as one system. The only unbalanced outside force along the direction of motion is the hanging block's weight, 10 N, and the total mass is 4.0 kg: a = 10/4.0 = 2.5 m/s².

(c) The hanging block accelerates downward, so the net force on it points down. The upward tension must therefore be less than its 10 N weight. If the tension were 10 N, the hanging block wouldn't accelerate at all.

Calculation, using the block on the table: T = m a = (3.0)(2.5) = 7.5 N. Check with the hanging block: 10 − T = (1.0)(2.5) gives T = 7.5 N.

6Problem 6, Free response

  • Calculation
  • Which changes
A worker pushes a 40 kg crate across a level floor with a horizontal force of 80 N, and the crate moves at a constant velocity.
  1. What is the size of the friction force on the crate? Explain using Newton's first law.
  2. Find the coefficient of kinetic friction.
  3. The worker increases the push to 160 N. Find the crate's acceleration.
  4. A classmate predicts that pushing with 320 N will double the acceleration from part (c). Is that right? Explain.
Show solutionHide solution

Model answer

(a) Constant velocity means zero acceleration, so the net force is zero. Friction must balance the push: 80 N, opposite the motion.

(b) The normal force equals the weight, (40)(10) = 400 N. So μk = 80/400 = 0.20.

(c) Kinetic friction doesn't depend on speed, so it stays 80 N. Net force = 160 − 80 = 80 N, and a = 80/40 = 2.0 m/s².

(d) No. With a 320 N push the net force is 320 − 80 = 240 N, three times the net force in part (c), so the acceleration is 240/40 = 6.0 m/s², three times as large. Acceleration is proportional to the net force, not to the applied force.

7Problem 7, Multiple choice

  • Graph
  • Calculation

The graph shows the velocity of a 2.0 kg cart moving along a straight track. During which interval is the magnitude of the net force on the cart greatest, and what is it?

01234567802468time (s)velocity (m/s)
  1. Choice A: 0 to 3 s; 4.0 N
  2. Choice B: 3 to 6 s; 12 N
  3. Choice C: 6 to 8 s; 6.0 N
  4. Choice D: 6 to 8 s; 3.0 N
Show solutionHide solution

Worked solution

The net force is m a, and the acceleration is the slope of the velocity–time graph.

0 to 3 s: 6/3 = 2.0 m/s². 3 to 6 s: zero, since the velocity is constant (choice B mistakes velocity for force). 6 to 8 s: (0 − 6)/2 = −3.0 m/s².

The largest magnitude is 3.0 m/s², from 6 to 8 s, so the net force is (2.0)(3.0) = 6.0 N. Choice D gives the acceleration, not the force.

Answer: C.

8Problem 8, Multiple select

  • Conceptual
  • Which changes

A block sits at rest on a rough ramp. The ramp is tilted a little more steeply, and the block still does not slide. Compared with before, which two quantities have increased? Select two answers.

θ
  1. Choice A: The static friction force on the block
  2. Choice B: The normal force on the block
  3. Choice C: The component of the block’s weight along the ramp
  4. Choice D: The block’s weight
Show solutionHide solution

Worked solution

The block is at rest, so the forces balance in both directions.

Along the ramp: friction balances the component of weight along the ramp, fs = m g sin θ. A steeper ramp has a larger sin θ, so both of these increase. A and C are correct.

Perpendicular to the ramp: FN = m g cos θ. As θ grows, cos θ shrinks, so the normal force decreases. B is wrong.

The weight, m g, doesn't depend on the ramp at all. D is wrong.

Answers: A and C.

9Problem 9, Free response

  • Experimental design
Design an experiment to test whether a cart's acceleration is proportional to the net force on it when the mass stays the same. You have a low-friction cart on a level track, a string and a pulley at the end of the track, a hanger with a set of 10 g and 20 g slotted masses, and a motion sensor.
  1. Describe your procedure.
  2. Students often start with all the slotted masses on the cart and move them to the hanger one at a time. Explain why that is a good idea.
  3. What would you graph, and what result would support the claim?
Show solutionHide solution

Model answer

(a) Tie the string to the cart, run it over the pulley, and attach the hanger. Release the cart from rest and use the motion sensor to measure its acceleration (the slope of its velocity–time graph). Repeat for several different hanging masses, doing a few trials for each.

(b) Treat the cart, the hanger, and all the slotted masses as one system. The net force on that system is the weight of whatever is hanging. Moving masses from the cart to the hanger changes the net force but keeps the total mass of the system the same, so mass is truly the controlled variable.

(c) Graph acceleration on the vertical axis against the hanging weight (the net force) on the horizontal axis. If acceleration is proportional to net force, the points fall on a straight line through the origin. The slope should be 1/mtotal.

If the line crosses the horizontal axis a little to the right of the origin, it's a sign that a small friction force had to be overcome before the cart moved.

10Problem 10, Multiple choice

  • Conceptual

Two students pull on opposite ends of a rope. Each student pulls with a force of 200 N, and the rope doesn’t move. What is the tension in the rope?

  1. Choice A: 0 N
  2. Choice B: 100 N
  3. Choice C: 200 N
  4. Choice D: 400 N
Show solutionHide solution

Worked solution

Tension is the size of the pull at each end of the rope. Each end is pulled with 200 N, so the tension is 200 N.

One way to see it: replace one student with a hook in a wall. To keep the rope still, the hook must pull with 200 N, exactly like the student did. Nobody would say the tension is 400 N in that case.

The forces on the rope add to zero, which is why it doesn't accelerate, but that doesn't make the tension zero.

Answer: C.